Motorbunny BUCK Cover: Fit, Care, and Cleaning Tips

Quick answer

Properly fitting and regularly cleaning your Motorbunny BUCK Cover protects the saddle cushion and keeps your machine looking fresh. Follow these steps for best results.

Step-by-step care and cleaning guide

1. 1. Remove and inspect the cover: Unfasten the four Velcro straps from the Motorbunny BUCK saddle. Check for any stains, debris, or wear before cleaning. Common mistake: pulling the cover off without releasing all straps can stretch the nylon. Always unstrap completely to avoid damaging the cover.
2. 2. Hand wash with mild soap: Fill a basin with cool water and a small amount of mild soap (like dish soap). Submerge the cover and gently scrub soiled areas with your fingers or a soft cloth. Avoid bleach or fabric softener. Common mistake: using hot water can shrink or warp the nylon. Stick to cool water and mild soap to preserve the water-resistant coating.
3. 3. Rinse thoroughly and air dry: Rinse all soap residue under running cool water. Squeeze out excess water without wringing. Hang the cover to dry away from direct heat or sunlight. Common mistake: machine drying or wringing can break the nylon fibers and weaken the Velcro. Air drying in a well-ventilated area keeps the cover flexible and the Velcro intact.
4. 4. Reattach the cover correctly: Once fully dry, align the cover over the Motorbunny BUCK saddle. Secure each of the four Velcro points snugly—not overtight. Check that the cover lies flat and doesn't bunch. Common mistake: leaving slack causes the cover to shift during use and reduces protection. A flat, snug fit ensures the cover stays put and the saddle stays protected.

Product facts

• Motorbunny BUCK Cover: Water resistant nylon cover with 4 Velcro securing points, hand wash with soap and water, quick dry. The Velcro points keep the cover snug during use, and the easy hand-wash routine means you can refresh it in minutes without special products.