Motorbunny Original用E-Stimシリコンアタッチメント：TENS設定

Quick answer

Mount the E-Stim Silicone Attachment on your Motorbunny Original, connect the included TENS unit to the conductive silicone, and start at the lowest intensity. Test the sensation on your hand or thigh before riding, and keep the TENS unit within easy reach.

Step-by-step E-Stim setup for Motorbunny Original

1. Inspect the attachment and TENS unit: Before mounting, check the conductive silicone area for tears or debris and confirm the TENS unit has fresh batteries. Common mistake: skipping the inspection and discovering a damaged conductive pad mid-session. A quick pre-check prevents interruptions and keeps the conductive surface clean.
2. Mount the attachment on the Motorbunny Original: Secure the E-Stim attachment onto the machine following the standard attachment mounting method for your model. Common mistake: not seating it fully, which can cause wobble and inconsistent skin contact. Push down firmly until the attachment sits flush before you add stimulation.
3. Connect the TENS unit to the conductive silicone: Attach the TENS unit leads to the conductive section as directed by the included instructions. Common mistake: connecting leads while the unit is powered on; always connect with the unit off. Power off before connecting or disconnecting leads.
4. Test the sensation away from sensitive areas: Turn the TENS unit on at its lowest setting and test on your hand or thigh to feel how the current ramps up. Common mistake: starting at a higher intensity because the lowest setting feels like nothing on your hand. Your hand tolerates more than sensitive skin, so treat the lowest setting as your starting point, not your target.
5. Position yourself and adjust contact: Lower yourself onto the attachment so the conductive area makes consistent contact, then adjust your position until the sensation is steady. Common mistake: gripping too hard and losing contact, which can cause a sudden spike in sensation. Keep your weight settled rather than bouncing to maintain even contact.
6. Increase intensity gradually during the ride: Raise the TENS intensity one step at a time, pausing between steps to let the sensation settle. Common mistake: chasing a stronger sensation too quickly, which can feel sharp rather than pleasurable. Small increments give you more control than large jumps.
7. Stop and disconnect safely: When you finish, turn the TENS unit off before disconnecting the leads, then remove the attachment and clean the silicone according to the care instructions. Common mistake: pulling leads while the unit is on, which can cause an uncomfortable jolt. Power down first, then disconnect and clean.

Product facts

• E-Stim Silicone Attachment for Motorbunny Original w/TENS unit included: The patent-pending E-Stim attachment combines platinum-cured silicone with a specially designed conductive silicone, and a TENS unit is included. You get both the riding surface and the electrical stimulation hardware in one purchase, so you can set up without sourcing a separate TENS unit.