Bunny Slope Attachment for BUCK: Riding Tips and Silicone Care

Quick answer

Mount the Bunny Slope on BUCK, start at the lowest power setting, and adjust your position before increasing intensity. After each session, clean the silicone promptly, dry it fully, and store it separately from other attachments.

Step-by-step: ride, clean, and store the Bunny Slope

1. Inspect and mount the attachment: Check the Bunny Slope for dust or damage, then seat it securely on BUCK according to the machine's mounting instructions. Common mistake: rushing the mount and leaving the attachment loose before powering on. Give the attachment a firm tug after mounting to confirm it is seated.
2. Set a low starting power: Begin at the lowest setting and increase gradually. The Bunny Slope is built to transmit Motorbunny's full vibration power, so starting low gives you room to adjust. Common mistake: jumping to a high setting before you have found a stable position. Decide on your stopping point before you start increasing power.
3. Position your body for comfort: Lower yourself onto the Bunny Slope and shift your weight until you feel stable and the attachment contacts the intended area. Use a mirror or a partner to check alignment if needed. Common mistake: holding tension in your hips instead of letting your weight settle. If you feel pressure in the wrong place, dismount and reposition rather than pushing through.
4. Ride with small adjustments: Make small changes in angle and pressure rather than large movements, and pause whenever you need to. Common mistake: continuing after discomfort begins because you are close to a preferred setting. Stop and reset if any position feels unstable.
5. Power down and remove the attachment: Turn BUCK off before dismounting, then remove the Bunny Slope carefully. Common mistake: pulling the attachment off at an angle that stresses the base. Keep the machine off until the attachment is fully removed.
6. Clean the silicone promptly: Wash the Bunny Slope with mild soap and warm water, rinse thoroughly, and avoid harsh cleaners. Common mistake: letting residue dry on the surface, which makes cleaning harder. Clean before storage, not the next day.
7. Dry and store separately: Let the attachment air-dry completely, then store it in a clean, dry container away from sharp objects and other materials. Common mistake: putting it away damp or pressed against another attachment. Check that the surface is fully dry before closing the container.

Product facts

• "Bunny Slope" Silicone Attachment for BUCK: The Bunny Slope is designed as Motorbunny's entry-level attachment and is made to make mounting easier for riders with physical limitations. That design intent supports a slower, more accessible first ride, so you can focus on positioning and control familiarity before adding intensity.